EE046-T11

• 产品介绍

Condensation Monitor The EE046-T11 condensation monitor helps to prevent condensation on critical cold spots. With the help of its relative humidity (RH) sensing element, it reliably detects the danger of condensation just before it occurs. Mounting Options The EE046-T11is available in two variants. The wall / pipe mount type is appropriate for installation on flat surfaces and on pipes with a maximum diameter of 50 mm (2”). It is mounted on cooling ceilings, on cooling or cold water piping, cooled surfaces and chilled beams. The snap-on type can be mounted on plastic and aluminium composite pipes with 16 mm or 20 mm diameter. It’s typical applications are cooling and heating by concrete core activation. Reliable Anti-Condensation Safe Guard Condensation on a surface occurs when the relative humidity of the air close to the surface reaches 100 %RH. Because of the very good thermal coupling with the surface, the EE046-T11 measures the RH of the air directly at surface temperature. Its properties make it the ideal choice for applications where control guards are required to prevent dripping or mould. Early Detection of Condensation Risk The relay output provides an early warning before condensation actually happens. It also indicates a power supply failure or a broken cable. A status LED indicates normal operation, alarm or power supply failure. The E+E proprietary coating protects the humidity sensor against dust and dirt

EE046-T11 冷凝监测器有助于防止关键冷点出现冷凝。借助其相对湿度 （RH） ä¼ æ„Ÿå…ƒä»¶ï¼Œå®ƒå¯ä»¥å¯é åœ°æ£€æµ‹åˆ°å†·å‡çš„å±é™©ï¼Œé˜²æ­¢å†·å‡å ‘生。

当靠近表面的空气的相对湿度达到 100 %RH 时，就会发生表面结露。由于与表面的热耦合非常好，EE046 直接在表面温度下测量空气的 RH。其特性使其成为需要控制防护装置以防止滴落或发霉的应用的理想选择。

继电器输出在冷凝实际发生之前提供早期警告。它还指示电源故障或电缆损坏。状态 LED 指示正常运行、警报或电源故障。E+E 专有 涂层可保护湿度传感器免受灰尘和污垢的影响。